BAE Multizone BI Chamber — Discovery Checklist

Partial answers are fine — capture what's known and fill gaps on a call or site visit. Send controlled data only through approved export-control channels.

Current Accel-RF BI Stands

8 total: 7 HPA, 1 driver amp · 16 DUTs each

0/11

In-House LN2 BI Stands

2 total · 4 DUTs each

0/6

Temperature range in useMinimum and maximum setpoints
Is sub-ambient (cold) testing a requirement for the replacement?Or just how the current stands were built
Cold plate size and DUT mounting method
DC and RF power per DUT
Device types tested on these stands vs. the Accel-RF stands
What isn't working well with the LN2 approachConsumables, safety, uptime, temperature stability

Requirements for the New Systems

Multizone BI — Delta V chamber, Despatch RBC, in-between, or standard stand

0/7

Target DUT count for HPAs and driver ampsNow and over the next 12–24 months
Maximum power dissipation per DUT, plus total heat load per system
Temperature range required (high and low)Plus uniformity and stability requirements
Number of independent temperature zones per systemDoes "multizone" mean separate chambers, shelves, or per-DUT control?
Should the new systems accept existing Delta V boards and fixtures?
Applicable test standards or profilesMIL-STD-883, ESS profiles, internal specs
Typical test durations and cycle profiles

ESS Lab Facility

Lower ceilings — smaller form factor preferred

0/6

Ceiling height and overhead obstructionsDucts, sprinklers, lighting — more detail the better
Floor space available and door/elevator dimensions for move-in
Electrical at the planned locationVoltage, phase, amperage
Cooling water availabilitySupply temperature and flow
Exhaust or HVAC limits on heat rejected into the room
Floor loading limits, if applicable

Data and IT

0/3

Network connectivity requirements or restrictionsStandalone vs. networked, cyber/IT approval process
Preferred data format and reporting needs
Traceability or calibration requirements to design around

Program and Schedule

0/4

Target install date and program milestones driving it
Budget cycle and expected PO timing
Single phased buy or multiple orders?
Who else at BAE should be involved in the early technical review?

BAE Systems

Harold Andrews — Eng Prin – Test, Electronic Combat Solutionsharold.andrews@baesystems.us
Kevin Veilleux — BAE Systemskevin.veilleux@baesystems.us
Brandon Pritchard — BAE Systemsbrandon.pritchard@baesystems.us
Sergio Rivera — BAE Systemssergio.rivera@baesystems.us

Delta V Instruments

Chad Storey — Point of contact — bid phasechad@delta-v.com
Rob Caldwell — Delta V Instrumentsrob@delta-v.com
Bob Storey — Delta V Instrumentsbob@delta-v.com
Randy Williams — Delta V Instrumentsrandy@delta-v.com